![]() When I put it back together, I attached the lower portion of the gun and installed a C02 Cartridge. It looked dry, kinda cracked, and hard, so I lubed it up with silicon grease, and then wrapped some Teflon tape around the threads in front of that seal, making sure not to let any tape hang over and interfere with the internal workings of the valve. Anyway, I lubed the 'seals' up good with some lightweight silicon based grease, and then as I was re-assembling, my eye caught that '0-ring' like seal around the threaded portion of the valve that you twist into the body of the gun (with pliers) to hold all the valve parts inside. ![]() Most of the seals inside of the gun are made from hard plastics like nylon that really wouldn't wear out easily or harden and crack, testament to the to 'no o-ring' design, so I wasn't quite sure why it leaked.
0 Comments
Leave a Reply. |