It is recommended to use the test figures 11Ilda12K.bin or 12Ilda30K.bin in Laserworld Showeditor The test picture shall at least contain an L-shaped line, a rectangle, a circle and some single dots. Select a test figure with various different shapes.Set the scan speed in the software to 50% of the value specified by the manufacturer (see manual of your show laser light system).There are several approaches to determining the correct scan speed. ![]() The behavior of the scanning system in different projection angles is not linear and every scanner type has different behaviour and a different relation between the scan angle The scanĪngle of most scanner systems is much wider, up to 60° or even 80°. The value stated as ILDA standard is only valid for an 8° output angle. The scan speed according to the ILDA specifications does not necessarily correlate with a proper show output quality. ![]() To determine the optimal scan speed is difficult. It is measured in Points Per Second (pps), often stated as Kilo Points Per Second (1 kpps = 1000 pps). ![]() The scan speed of a show laser light system is the maximum speed the mirrors on the Galvo motors can move at without distortion. Adjust Scanner Settings, Set The Correct Scan Speed / Scan Rate (kpps)
0 Comments
Leave a Reply. |